Wine Rack

This is the perfect gift for loved ones or a friend

Materials List

• 25″ of 1×6 = 1.042 BF
• 25″ of 1×8 = 1.389 BF
• 9″ of 1×2 = .125 BF
• 1 – 1x4x6′ = 2 BF
• 1-1/4″ Pocket Hole Screws
• 1-1/4″ Wood Screws
• 1-1/4″ Brad Nails
• Wood Glue
• Hanging Hardware

4.556 BF * $4.75 = $21.64

Cut List

• 1 – 1×6 @ 25″ (stemware hanger)
• 1 – 1×8 @ 25″ (back)
• 2 – 1×2 @ 4-1/4″ (sides)
• 2 – 1×4 @ 25″ (ledge and front)
• 2 – 1×4 @ 2-3/4″ (sides)

Tools

• Tape Measure
• Pencil
• Speed Square
• Drill with Countersink Drill Bit
• Circular Saw
• Kreg Jig
• Jigsaw
• Brad Nailer or Hammer

Using a jigsaw, cut out the stemware slots as shown

Drill 3/4″ pocket holes into the back board facing down and use 1-1/4″ pocket hole screws to attach it to the stemware rack. Alternately, you can use 1-1/4″ brad nails and wood glue to build this wine rack.

Attach the 1×2 side pieces with 3/4″ pocket holes and 1-1/4″ pocket hole screws. Attach the 1×2 to the stemware rack with 1-1/4″ brad nails nailed from underneath.

Drill 3/4″ pocket holes into the 1×4 ledge and attach it to the back with 1-1/4″ pocket hole screws. You can also nail in 1-1/4″ brad nails on top to attach the ledge to the 1×2 sides.

Drill 3/4″ pocket holes into the 1×4 sides and attach it to the back with 1-1/4″ pocket hole screws. Use glue on the joint where it meets the ledge.

Pre-drill countersunk pilot holes into the front board and attach with 1-1/4″ wood screws. Fill the holes with wood putty or wood plugs.