Spiky Crayon Easter Egg

by rasmus_pf in Craft > Art

722 Views, 3 Favorites, 0 Comments

Spiky Crayon Easter Egg

PXL_20220829_143037735.MP.jpg

Hi, today I want to show you how you can make a spiky easter egg.

We all know the traditional way of making easter eggs by painting or dyeing them. But did you know, you can also use crayons to make them look amazing - and it isn't in the way you might think.

Supplies

PXL_20220829_122541323.MP.jpg
PXL_20220829_120803345.MP.jpg
PXL_20220829_142205572.MP.jpg

What you will need:

  1. a raw egg
  2. a needle
  3. some crayons (whatever colors you like)
  4. a candle
  5. a toothpick and some string to hang the egg

Emptying the Egg

PXL_20220829_120743028.MP.jpg
PXL_20220829_120944515.MP.jpg
PXL_20220829_121036082.MP.jpg

First you need to remove the egg white and the yolk by making two holes, at the top and the bottom of the egg.

One of the holes needs to be enlarged, about as big as shown in the picture.

Place your mouth over the small hole and start blowing air into the egg, so that the egg white and yolk get pushed out of the larger hole.

Now clean the inside of the egg by pouring some water through the large hole, shaking it around and pouring it out again to remove any residues inside the egg.

Making the Spikes

PXL_20220829_154847658.MP.jpg
PXL_20220829_125519831_exported_14360.jpg
PXL_20220829_125519831_exported_17659.jpg
PXL_20220829_125519831_exported_19225.jpg
PXL_20220829_125519831_exported_28555.jpg
PXL_20220829_125519831_exported_29788.jpg

Next we can begin decorating the egg with spikes.

Here you can be creative with your designs and let your imagination run free.

To make a spike take a crayon and hold it over the flame of the candle until a droplet of molten crayon starts forming.

Now lower the hot droplet towards the egg until it attaches itself to the surface and slowly lift the crayon in order to draw out the spike, as shown in the pictures.

Removing Failed Spikes

PXL_20220829_123405973.MP.jpg
PXL_20220829_150752511.MP.jpg
PXL_20220829_140359979_exported_10362.jpg
PXL_20220829_140359979_exported_13761.jpg
PXL_20220829_140359979_exported_32220.jpg
PXL_20220829_140359979_exported_42483.jpg

In case you want to remove a spike, because it didn't turn out the way you wanted, just wait a few seconds for the wax to cool down and harden. If you then apply pressure from the side (e.g. with the spine of a knife) it will snap right off.

Now you can try again and keep making spikes.

Finishing Touches

PXL_20220829_142354901.MP.jpg
PXL_20220829_142756905.MP.jpg
PXL_20220829_142856288.MP.jpg
PXL_20220829_143220664.MP.jpg

If you are happy with how your egg is looking you can now make the loop for hanging the egg.

For that you need to cut a piece out of a toothpick, as shown in the picture and then tie a knot around it, forming a loop.

Now insert the toothpick piece into the larger hole. The toothpick will flip over on the inside and prevent the loop from slipping out.

You can now hang the egg wherever you like and enjoy the sight :)