Put-together Pot
This is a flowerpot made out of a soda can and some solder.
Do not drink out of the can because a piece of solder might suddenly fall off and possibly choke you,
and it may have sharp edges.
It can be used for a plant pot or to hold a flower. It is put together using random items I found lying around, this gives it it's name.
You Will Need:
An empty soda can
A soldering iron
A lot of solder
Jumper wires
Tape
Sandpaper
Wire cutter
Other totally random items (anything you like)
Cut the Top Off the Can and Fill It With Patience
I'm serious. You will need a LOT of that stuff.
Sand It
Sand the sharp edges so that they lose their sharpness.
Cover It in Solder
Then use the soldering iron to melt it so it sticks.
This is to cover the sharp edges.
Poke a Hole in the Side (near the Opening)
This is to attach the handle. Do the same to the opposite side.
If this is going to be a plant pot you can make a hole the bottom so that water can drain out.
Solder a Jumper Wire (a.k.a Handle) to the Holes
Put a lot of solder to make sure it does not break.
Cover the Solder With Tape
This is to hide the messy mess of solder.
Enjoy your randomly put together pot.
HAPPY NEW YEAR!!!!!