Police Badge in Epoxy River Wall Decor

Today we will make a police badge, casted in epoxy river wall decor!

- Police badge (this one is the hardest to obtain)
- Oak slab
- Epoxy
- Epoxy pigment

We start off by removing the bark from the oak slab using a chisel!

Using an angle grinder with a flap disc, we smoothen the live edge! Make sure all the bark is removed after this part of the build!

Using a track saw, we create the first half of the river.

After removing the first half of the river with the track saw, we now have a straight edge. Place this straight edge to the fence of the table saw to remove the second half of the river.

At the mitre saw station, we use a stop block to cut all the pieces to exactly the same size. In this build I will be making 3 river wall decors with 3 police badges, so in total I need 6 halves.

Lay the pieces on the ground and figure out which pieces fit best with each other.

Using a planer, we flatten the parts so they are all at the same thickness.

Using some scrap pieces of plywood, we make molds for the pieces to fit in! Make sure to take the dimensions so that the pieces fit snug in the mold.

Using a bit of epoxy we seal the live edges. This ensures the wood won't release bubbles when the epoxy is casted inside the river.

Place the pieces in the mold and make sure the mold is level. This way when the epoxy is casted, you ensure it won't overflow on one side!

The river will be poured in two sessions. The first layer will be colored. The badge will be added and the second layer will be transparent, so that the police badge will lay on the colored layer.

Pour the first layers. As you can see I have used 3 colors. Fully transparent, black and blue.

Before the frist layer of epoxy is fully hardened, press in the police badge.

The second layer of epoxy is transparent. This way you can clearly see the badge through the epoxy!

When the epoxy is completely cured, you can remove it from the mold.

Use the track saw to make the first cut to use as a reference point. After this use the fence of the table saw as a guide for the freshly cut side to cut the piece to the desired dimensions!

Rout the edges the way you want. I left one piece as is, one got a round over edge and one a chamfered edge.

After this comes the tedious task of sanding. We are going to sand the piece from 150 grit all the way up to 2000 grit! Everything above 1000 grit is wet sanding.

After hours of sanding, you are NOT done! Apply your polishing compound to the epoxy and use a car polish machine with a polish pad (sponge) to polish the epoxy until shiny!

Almost done! Apply the finish! In this case I used danish oil. Rub it in nice and remove any excess if necessary. Apply multiple layers, I recommend about 2-3.

Almost done! Well, the project is done, now we have to put it in a box and go and gift it to the police!

Did you enjoy this build? Than please support me by subscribing to my YouTube channel! You can do that by clicking the subscribe button below! Underneath the subscribe button is the video about this build!