NITEFINDER SHOTGUN MOD

NITEFINDER SHOTGUN MOD

• 5 Q-tips
• used 4/10 shot gun shell
• normal printing paper
• 2 chunks of 1/2*1/2 foam
• scissors

Cut the Q-tips where the cotton starts. Do not mess up the part that the cotton is attached to that is what you are using for the ammo.

Now size the shot gun shell on both side of the paper cut a mark in the paper. Fold at the cuts. Then cut a all the way down the paper.

Now, carefully wrap 2 times a round the shell in the paper you just cut. Cut a mark in the paper. Fold at the cuts. Unwrap the paper.Cut at the fold.Wrap it again and tape it. Finally, slide the shotgun shell out of the paper shell.

Take your paper shell and your foam. Put one pieces of foam in the front of the shell. Take the Q-tips and put them the shell by groups of 3. I use the left offer middle section of the Q-tips and push them the shell . Last, put the other foam in the end.

Sorry about this but this will only work on a gun that the air Restrictors Removed or with a long barrel . I would make that a DIY but i all ready removed them. Just put the shell in barrel and fire!!!

PS. I don't now how well the range will be with out Restrictors Removed