Making Engraved Bracelets

𝗧𝗵𝗶𝘀 𝗶𝘀 𝗮𝗻 𝗜𝗻𝘀𝘁𝗿𝘂𝗰𝘁𝗮𝗯𝗹𝗲 𝘁𝗼 𝗹𝗲𝗮𝗿𝗻 𝗵𝗼𝘄 𝘁𝗼 𝗺𝗮𝗸𝗲 𝗲𝗻𝗴𝗿𝗮𝘃𝗲𝗱 𝗯𝗿𝗮𝗰𝗲𝗹𝗲𝘁𝘀 𝘄𝗶𝘁𝗵 𝗽𝗲𝗿𝘀𝗼𝗻𝗮𝗹𝗶𝘇𝗲𝗱 𝗹𝗲𝘁𝘁𝗲𝗿𝗶𝗻𝗴! 𝗛𝗼𝗽𝗲 𝘆𝗼𝘂 𝗳𝗶𝗻𝗱 𝘁𝗵𝗶𝘀 𝗵𝗲𝗹𝗽𝗳𝘂𝗹 𝗮𝗻𝗱 𝗲𝗻𝗷𝗼𝘆 𝗺𝗮𝗸𝗶𝗻𝗴 𝗶𝘁!

- Chain (enough to complete you bracelet, wrap around your wrist to find out how much you need)

- Lobster claw clas(to open/close the bracelet)

- Engravable metal plate (place to put the engravement on)

- Pliers or scissors (to cut the chain if needed)

- Letter metal stamps

- Jump rings (to clasp the lobster claws onto)

- Hammer

First, take your engravable metal plate and set it on something like a piece of wood so you won’t damage the surface of the table.

Take the letter metal stamps you will use in your engraving and line them up to make sure it all fits and has even spacing.

Once you are ready to start, take your first letter and place it on the plate, then hammer it down. Make sure you don’t hit the stamp multiple times. If you do, the stamp may shift and you will end up with multiple imprints of the letter. One hard and firm hit will get you the best result.

Continue with other letters like step 3.

When you are done with your lettering, measure the chain to your desirable length. Then take it and insert it into the holes on the plate.

Put the jump rings on both ends of the chain and close it with pliers. After that, add your lobster claw clasp onto the jump rings.

And now you should be done with your bracelet / jewlery! Thanks for trying this craft out!