Make a Jeweler

Screen Shot 2021-11-15 at 9.50.23 AM.png

Hi guys, me again but this time showing you how to make a Jeweler on Tinkercad, really fancy and cute to make. Enjoy!

Let's Start

Screen Shot 2021-11-15 at 9.54.21 AM.png

Screen Shot 2021-11-15 at 10.04.32 AM.png

To begin we are going to pick a cylinder. The measures are length: 40cm, width: 40cm and height: 1cm. then we are going to drag a ring and use the same measure as the cylinder. The must be the same measure.

Bottom

Screen Shot 2021-11-15 at 10.05.42 AM.png

Screen Shot 2021-11-15 at 10.07.24 AM.png

After having both, the cylinder and the ring as the same measure we put the ring on top of the cylinder.

Middle

Screen Shot 2021-11-16 at 7.05.02 PM.png

Screen Shot 2021-11-16 at 7.05.06 PM.png

Screen Shot 2021-11-16 at 7.09.57 PM.png

The middle part is a rectangle with 50cm of height, length: 50cm and width: 50cm. Once you have the bottom and the rectangle try to center it in the middle.

Top

Screen Shot 2021-11-16 at 7.12.33 PM.png

Screen Shot 2021-11-16 at 7.16.25 PM.png

Screen Shot 2021-11-16 at 7.14.43 PM.png

Screen Shot 2021-11-16 at 7.13.34 PM.png

Pick a heart. The measures: Height: 30cm, length: 33cm cm and width: 12cm. With the small cone that is on top of the heart you are going to lift up 40cm.

To Finish

Screen Shot 2021-11-16 at 7.25.13 PM.png

Screen Shot 2021-11-16 at 7.27.38 PM.png

Finally we put the heart on top of the rectangle. You are free to change the color of the pieces if you want.

Done

Screen Shot 2021-11-16 at 7.28.48 PM.png

Done!! I hope your jeweler might end similar to this.