Junk Mail Flower

by Barry Neeson in Craft > Paper

853 Views, 10 Favorites, 0 Comments

Junk Mail Flower

Scribbling on regardless thumbnail_Junkmailflower_instructables.jpg
JMF_promo1.jpg
JMF_promo3.jpg
JMF_01.jpg

Hi,
In this instructable I will be showing you how to make Flowers out of you're junk mail. Its a nice way of up-cycling something that most of us hate getting through the door.

At the time of writing this instructable we are amid the Covid19 lock down/pandemic so you may want to let any junk mail you are going to use sit for the 72hr period suggested that the virus can survive on a surface. (the junk mail used in this instructable had been sat for a few weeks)

I should also note that you can use the steps in this instructable to make flowers from other materials such as paper, old music sheets,magazines and books.

Supplies

Junk mail.

Scissors

Glue or double sided tape

The Stem

JMF_02.jpg
JMF_03.jpg
JMF_04.jpg

Take a piece of your junk mails and run some glue along one edge.
Roll it into a thin tube from the unglued end towards the glued end (if you have trouble getting started you can use a pencil to help wrap the junk mail around)

Cutting the Petals

JMF_05.jpg
JMF_06.jpg
JMF_07.jpg
JMF_08.jpg
JMF_09.jpg

This step will vary depending on the size and shape of the junk mail you are using.

In this case I am quarter folding a magazine type bit of junk mail so that i can cut out numerous petals at once.
The size and shape of the petals is entirely up to you, the only proviso i would suggest is keeping a flat edge at the bottom of the petal for more surface area to put glue on.

Attaching the Petals to the Stem

JMF_10.jpg
JMF_11.jpg
JMF_12.jpg
JMF_13.jpg
JMF_14.jpg
JMF_15.jpg
JMF_16.jpg
JMF_17.jpg
JMF_18.jpg
JMF_19.jpg
JMF_20.jpg
JMF_21.jpg

Run some glue around the base of the petal and then attach it to the end of the stem by wrapping it around. repeat this moving the petals around the stem so they start to overlap each other.

After you have a few on you can start to angle the petals out to create more volume.

You can also start to fold some of the petals after they have been attached to create volume/rose type look.

keep doing this until you are happy with the amount of petals.

Attaching Some Leaves

JMF_22.jpg
JMF_23.jpg
JMF_24.jpg
JMF_25.jpg
JMF_26.jpg

Taking a long strip of junk mail, fold it in two and cut it into the shape of a long leaf (again the exact size and shape is up to you) and again i would leave a slat line at the base.


Put some glue at the base and attache them about half way down the stem on either side.

Finished!!

JMF_promo8.jpg
JMF_27.jpg
JMF_promo2.jpg
JMF_promo4.jpg
JMF_promo5.jpg
JMF_promo6.jpg
JMF_promo7.jpg

And you're done!

This instructable was made as part of the Scribbling on Regardless project run by BOOM! Community arts in response to the Covid19 lockdown scenario in an attempt to provide accessible activities for people and families stuck at home.

As always I hope you enjoyed this instructable and as always, thoughts, comments and even photos of your own Junk mail flowers are welcome in the comments section below.

Stay safe and wash your hands.

;)