How to Install a Storm Door Closer

Today I show how to install a Door Closer, these can be used on Storm Doors or Screen Doors. I have also included a video from my Youtube channel.

Tools Needed

What's Needed:

Hammer

Phillips Screw Driver

Drill

1/16" and 1/8" Drill bits

Nail or Center Punch

Pencil or Pen

Where to Put It

The first thing you need to do, is too decide where to install it. These can be install on the Top or the Bottom of the Door. I prefer the Top, I guess because I'm tall.

Bracket

Note the arrow on this bracket, it must be installed towards the Storm or Screen Door.

Hold the bracket to the Door casing, make sure it is 1/4" inch away from the front edge, also leave enough room at the Top to install the Pin. Then mark the location of the holes with a pen or pencil

Now take a Nail or Center Punch and make a dent into the wood, so you can drill

Drill

Drill with a 1/16" drill bit, this will help prevent the wood from splitting

Screw on the Bracket

Now use the 4 longer screws with the Closer, Screw them with your Phillips Screw Driver

Now install the lock mechanism onto the end, as shown in these pictures

Now install the closer using the short pin to the bracket as shown in the pictures

Now with the Door shut, attached the other bracket as shown with the longer Pin.

Note if it's a Glass Door, it will go in the First hole, if it's a Wooden Screen Door, it will go into the second hole

Mark the spots for the 2 screws, use a Center punch or nail, then drill with a 1/8" drill bit.

Note take your time drilling, you only want to drill thru the first layer of the screen door.

DO NOT DRILL ALL THE WAY THRU

Install the 2 Shorter screws into this bracket, install one screw with the pin in the bracket, then take pin out and install the other screw.

Be sure and install towards the center location, this will give you some room for adjustment, if needed

Now with the bracket screwed onto the Storm door, open the door, pulled the cylinder out and lock it in place. Then install the long Pin into the First hole.

Now your Door Closer is installed, Thanks for checking out my Instructable.