Handpan/Pantam Stand

Very easy to build stable stand for handpans and metal tongue drums.

Fits 53 and 46 cm models including bottom notes

SECURITY NOTE: To use the tools described here please refer to their instructions for use. Only use them if you are able to handle them safely. Always pay attention to safety for yourself and others. I assume no liability for injuries or damages to your instrument or other objects!

Material:

5-6 cm hinge

2-3 mm rope

Some small screws with washers and nuts

Board of plywood 52 x 37 cm, 10-12 mm thick

Tools:

Work table

Jigsaw with narrow fine saw blade

Drilling machine

Screwdriver

Wrench

Lineal

Pencil

Sandpaper

Draw the shape of the two parts on the wooden board. In picture no 1 you can see the most important dimensions. They apply to a 6 mm board. I used this for my first version because I had no thicker plate at that moment.

If you use 10 or 12 mm wood, what I recommend, the parts can be marked correspondingly narrower.

It is advisable to first saw out the parts a bit larger, afterwards they can be easily reduced with the jigsaw if needed.

Saw out the two pieces of wood with the jigsaw.

This works ideally with a saw holder, where the saw is attached to the table and the wood can be guided precisely.

Then round off the corners and edges with sandpaper.

Mark the hinge holes on the inside of the wooden pieces and drill the holes.

Attach the hinge to both pieces of wood with the small screws, washers and nuts.

Drill 4 holes. Fasten 2 cords so that the distance between the wooden parts on the ground at the front is about 35 cm.

Ready! :)