Foam Sword , Gun

I got bored and had some foam lying around so I made a sword and a gun out of it

First you need to a foam rectangle about 1" thick the length depends on how big you want your sword to be. Use a marker (Sharpie works best) to draw your sword on the foam

After your done drawing it cut it out with a knife

The handle on mine was very flimsy so I reinforced it by sticking a small rod into the handle and then taping it up with duct tape

I used the scraps for a gun I basically did the same steps as the sword but drew a gun I also cut it lengthwise in half so it was easier to hold I also did not put in a reinforcement