Fidget Spinner

by SukharevD028 in Workshop > Molds & Casting

439 Views, 0 Favorites, 0 Comments

Fidget Spinner

fidget.png

In this instructable I will teach you how to make a 3D printed fidget spinner!

inventor.PNG

Open up Autodesk Inventor Professional 2017

mm.PNG

Click on NEW to create a project and select standard(mm) in the metric folder. After you do this press create.

2D.PNG

Press on "Start 2D Sketch" and then select the XY plane to start making your fidget spinner.

circle.PNG

Use the circle tool to create two circles that are 22.1mm in diameter. Make sure that the circles are directly on top of each other.

dimension.PNG

Press on the dimension tool and select both dots in the middle of each circle, then make the line 32-35mm.

circles.PNG

Create two more circles 37mm in diameter that are in the same spot as your previous circles

lines.PNG

Create two vertical lines on each side of the circles

trim.PNG

Select the trim tool and trim the inside of each circle.

circular.PNG

Select the circular pattern tool and highlight all your work. Select the clicking tool and press on a dot in the middle of one of the circles. A fidget spinner with 6 sides should appear, change it to 3 sides.

finsh.PNG

Select "finish sketch" on the top right corner

extrude.PNG

Select the "extrude" tool and extrude your fidget spinner by 7mm.

fillet.PNG

Select the "fillet" tool and click on all three corners of your fidget spinner. Hold and drag to round out the fidget spinner to your liking.

round.PNG

Select the "fillet" tool again and select the front and back edge, set it to 2mm to round them off