Easy Ribbon Bow (2 Mins! No Sew!)

This is super easy to make bow using a ribbon and some PVA glue

You can make this in about 2 minutes flat!!

Dont believe me? Try it :)

Tools:

1. PVA glue

2. Scissors*

Material :Ribbon of your choice!

I have used Canada Fuchsia Satin Ribbon

*Note: Be careful using sharp instruments like scissors!

Cut 2 pieces of 6 inches (15 cm)

and one piece of 2 inches (about 5 cm)

Glue one end of the 6 inch piece using the PVA glue

Paste the ends to make a loop

Apply glue to one of the inner sides of the loop and press the ribbon to form a 8-shaped loop

Apply some glue at pinch of one of the 8.

Stick the other 8 at slight angle to it.

Apply a dot of PVA glue at the center of the ribbons and wrap the 3-inch piece around to form a loop.

Cut two more pieces of ribbon of about 4 inch each.

Cut a small 'V' at one end.

On the rear side of the bow, paste the two tails made earlier

... and your bow is ready in 2 minutes flat!

Have fun!