DoggyDaptive Water Bowl

by PaceOccupationalTherapy in Circuits > Assistive Tech

247 Views, 1 Favorites, 0 Comments

DoggyDaptive Water Bowl

a9Dv6.jpeg
IMG_0822.jpeg
O09vz.jpeg
Screen Shot 2022-04-25 at 2.51.48 PM.png
Screen Shot 2022-04-25 at 2.51.38 PM.png
Screen Shot 2022-04-25 at 2.50.42 PM.png

The DoggyDaptive water bowl is a hose connected water dispenser to a dog bowl. A sensor in the dog bowl allows for the bowl to be filled and stop automatically when the water reaches a certain height. Within the water dispenser, a sensor connected to an alarm allows for the dog's caretaker to be alerted when the water dispenser needs to be refilled. The design of this device allows for individuals with visual impairments to independently refill the water dispenser and thus care for a guide dog while including automation aspects to support pet care and maintain safety.

Supplies

(1) High/Low Water Level Sensor Detector Alarm 120 dB Red Strobe Siren

https://www.amazon.com/dp/B085Y4ZV1K?psc=1&ref=ppx...

(1) Extra Large Water Bowl for Dogs (1.25 Gallon) https://www.amazon.com/dp/B085Y4ZV1K?psc=1&ref=ppx...

(1) Short Garden Hose 3/4 in. x 5ft https://www.amazon.com/dp/B08T1HQ37Q?psc=1&ref=pp...

(1) Brass Garden Hose Fitting https://www.amazon.com/dp/B08T1HQ37Q?psc=1&ref=pp...

(1) Slimline Beverage Dispenser, 2.5-Gal https://www.amazon.com/dp/B08T1HQ37Q?psc=1&ref=pp...

(1) Water Float Valve with Adjustable Arm https://www.amazon.com/dp/B08T1HQ37Q?psc=1&ref=pp...

(1) 1/2" Hose Bibb https://www.amazon.com/dp/B08T1HQ37Q?psc=1&ref=pp...

IMG_0824.jpeg

First, remove the waterspout of the beverage dispenser and connect the hose bibb to the dispenser.

jPV7L.jpeg

In the second step, drill a hole through the water bowl and fit the water float valve through the hole, with the ball facing inside the bowl.

bWv9q.jpeg

Next, connect the hose to the water float valve, and tighten to seal the hole.

bGlCT.jpeg

After, connect the other end of the hose to the hose bibb that is attached to the water dispenser.

IMG_0830.jpeg
IMG_0831 2.jpeg
IMG_0832.jpeg

Attach the water level sensor to the back of the beverage container with command strips. Install the water level sensor by hanging it vertically inside the beverage dispenser.

IMG_0846.jpeg
IMG_0848.jpeg
IMG_0849.jpeg

Fill the water dispenser with water. When the alarm sounds, it is signifying a low water level in the dispenser. Refill the water dispenser through the hole on the top of the dispenser.