DIY Duct Tape Flip Flops

by Dammo3 in Craft > Duct Tape

2758 Views, 21 Favorites, 0 Comments

DIY Duct Tape Flip Flops

Screen Shot 2017-02-02 at 4.37.54 pm.png

These Duct Tape Flip Flops are made mostly out of duct tape. This means they are cheap, recycled by using previous materials, tough, waterproof and most importantly, wearable. It is optional to use coloured duct tape if you would like it to look 'fancier'.

Materials

DSC_0999.JPG

To make these duct tape thongs, you will need:

  • Duct Tape
  • Cardboard
  • Marker
  • Scissors
  • Flip Flops

Trace the Flip Flop Size Onto the Cardboard

DSC_1000.JPG
DSC_1001.JPG
DSC_1002.JPG

Place the thongs on the cardboard. Using the marker, trace the thongs. Then, cut out the shape with the scissors. You can discard any leftover cardboard.

Cover Cardboard in Duct Tape

DSC_1003.JPG
DSC_1004.JPG
DSC_1006.JPG

Start by covering one side in duct tape. Then, turn it over and do the same to the other side. Next, cut off all excess duct tape, so it resembles the shape of a flip flop once again.

Make the Straps

DSC_1008.JPG

Using a long piece of duct tape (rather use more and trim than use too little), twist it until it resembles a strap.

Attach the Strap

DSC_1007.jpg
DSC_1010.JPG
DSC_1009.jpg
DSC_1011.JPG
DSC_1012.JPG

Mark where you believe the strap should be. Then, using the scissors, make a hole in the sole. Thread the strap through the hole and then duct tape it in place on the bottom of the flip flop. Next, cut the strap to the right length, thread it through the hole and tape that down as well.

Attach the Other Half of the Strap

DSC_1014.JPG
DSC_1013.JPG
DSC_1018.JPG
DSC_1016.JPG

With the remaining strap, tape it to the other strap. Like the other side, thread it through the hole and tape it to the bottom.

And You're DONE!

DSC_1018.JPG

You now have your own Duct Tape Flip Flops!