Crocodile Switch

by engineeringgood in Circuits > Assistive Tech

683 Views, 2 Favorites, 0 Comments

Crocodile Switch

3.5mm Male Jack.png
Long Wire.png
Crocodile Clips.png

The Crocodile Switch is another example of an assistive technology using everyday materials. It is a switch that uses crocodile switches so that it can empower children with special needs to use everyday items such as toys.

Supplies

For this Instructable, you will need the following items:

  • One (1) male 3.5mm jack
  • Long wire
  • Two (2) crocodile switches

Take the Long Wire. Clamp the Red Wire at the Third Notch (1.0mm)

Step 2.png

And Then Pull to Separate the Wire From the Insulation

Step 3.png

If you are using a strip gun, clamp the wire and pull the trigger quickly

Do the Same for the Black Wire, Leaving Slightly More Insulation on the Black Wire

Step 4.png

Unscrew Earphone Jack

Step 5.png

To unscrew, grip the pin with one hand and the shell in another, then turn in opposite directions

Thread the Stripped End of the Wire Thru the Shell

Step 6.png

Pass Black Wire Through the Hole in the Shorter Leg

Step 7.png

Wrap the Wire Around the Leg

Step 8.png

Pass Red Wire Through Taller Leg

Step 9.png

Wrap the Wire Around the Leg

Step 10.png

Use the Tools to Make Sure There Are No Stray Strands of Wire, and Pull Lightly to Test If Secure

Step 11.png

Solder Black Wire

Step 12.png

Solder Red Wire

Step 13.png

Visually Check That There Are No Stray Wires, Then Screw the Shell Back On

Step 14.png

Take the Other End of the Long Wire, Strip the Red and the Black Wire About 1.5 Cm

Step 15.png

Thread the RED Wire Through the Hole at the Back of the Red Crocodile Clip

Thread the red wire.png

You may need to open up the tube bigger

Remember to place the sleeve in the wire, so you can put it back after soldering

Loosen the screw, wind the exposed wire clockwise around the screw, and tighten the screw to secure the wire onto the crocodile clip

Solder the Wire Onto the Back of Crocodile Clip

Solder the wire.png

Replace the sleeve

Repeat for the black wire/crocodile clip