Clothes Peg Switch

by engineeringgood in Circuits > Assistive Tech

543 Views, 1 Favorites, 0 Comments

Clothes Peg Switch

3.5mm Male Jack.png
Long Wire.png
Clothes Peg.png
Leaf Switch.png

The Clothes Peg Switch is another type of an assistive switch. It is meant for children with disabilities so they can be empowered to to use everyday items.

Downloads

Clothes Peg Switch

Supplies

For this Instructable, you will need the following items:

  • One (1) Male 3.5mm jack
  • Long wire
  • One (1) leaf switch
  • One (1) clothes peg

Take the Long Wire, Separate the Black and Red Wire at One End for About 2 Cm

Step 1.png

Strip the Black Wire by About 1cm by Using the 3rd Notch on the Wire Stripper. Clamp the Wire at the Third Notch (1.0mm)

Step 2.png

If you are using a strip gun, clamp the wire and pull the trigger quickly

And Then Pull to Separate the Wire From the Insulation.

Step 3.png

Do the Same for the Red Wire, Leaving Slightly More Insulation on the Black Wire

Step 4.png

Strip the red wire a bit more

Unscrew Earphone Jack

Step 5.png

To unscrew, grip the pin with one hand and the shell in another, then turn in opposite directions

Thread the Stripped End of the Wire Thru the Shell

Step 6.png

Pass BLACK Wire Through Shorter Leg

Step 7.png

Wrap the Wire Around the Hole

Step 8.png

Pass RED Wire Through Taller Leg

Step 9.png

Wrap the Wire Around the Hole

Step 10.png

Use the Tools to Make Sure There Are No Stray Strands of Wire, and Pull Lightly to Test If Secure

Step 11.png

Solder BLACK Wire

Step 12.png

Solder RED Wire

Step 13.png

Visually Check That There Are No Stray Wires, Then Screw the Shell Back On

Step 14.png

Take the Other End of the Long Wire, Strip the RED Wire About 1.5 Cm

Strip the red wire more.png

Cut the BLACK wire about where the RED insulation ends. Then strip the BLACK wire about 1.5cm

Now Take the Leaf Switch. Using the Wire That You Just Stripped; Pass RED Wire Through Hole in the Bottom Leg

Pass the Red wire.png

Wrap the Wire Around the Hole

Wrap the wire around the hole.png

Pass BLACK Wire Through Hole in the Lower Leg

Wrap wire.png

Wrap the Wire Around the Hole

Wrap wire.png

Solder the Two Joints

Solder the joints.png

Now for the Clothespeg! Carefully Remove One of the Metal Rings From the Clothes Peg

Clothes peg remove.png

Position the Switch Such That the Lever Is Aligned With the Top Edge of the Peg.

Glue clothes peg.png

Use a glue gun to glue the switch in position (it’s OK to glue over the wires).

Test your Clothes Peg Switch with a toy!