Boat for Flash Floud

This is a boat that is used for flash floud and this takes 10 to 20 min to build. This boat uses dezien and science konlage. As design is used for making it compact and more eizyly able to styer and use things at home to make the boat. Also Design is used for the layers that protectyou from growing. in this boat science is used as for the turm boiance or flotebelate. the design of the layers is using science as it has a lot of boiant things in it that stop it from drowing.

You need

• 3x 2.5x1.5m cardboard
• 4x 1x1m cardboard
• 8x big bottle
• normal pet bottle
• broom
• plastic bag
• cutter
• 5 to 6milk book or cartun
• 2x brooms
• cutter
• plastic rape

A heads up whenever I say seel it up or the bottles should be sealed or anything to do with selling I mean plastic rape it up.

Frist get 2.5 by 1.5m and 1 by 1m cardboard if you don't have this big cardboard tape some other cardboards together. Also, make sure that you have the right measurements. Then take 3 of your other 1x1cm cardboard and cut them into 4 pieces each.

Then get all your 12 pieces and tape them to the 2.5 by 1.5m cardboard. Do this by taping it under and above the 2.5 by 1.5m cardboard. then tape all your sides together so they don't fall off because if they do you are most likely going to drown. I hope you don't drown.

Turn the boat that you have made till now upside down. Then get 8 big pet bottles and make sure the bottles are nicely sealed and have no holes. Also, there should be no water in the bottles. Then tape the bottles on the cardboard and make sure the other are no holes.

Then get another one of your 2.5 by 1.5 cardboard and get 5 to 6 milk bottles. Then seel the tape so that the water does not come in and you can do this by using a plastic rape. Also, there should be no milk in the milk books. Again make sure that there are no holes in the tape if there are seel them up.

Last, get your last 2.5 by 1.5m cardboard and just rape it with plastic rape. Then take your 2 layers that are not on the boat and tape them together again there should be no holes and tape it nicely that the layers don't fall off. if they do you might drown as the sudden change of bounce will cause you to drown.

Use the 2 layers that you have made and tape them to the boat. Then seel the gaps in the layers and also seel the top part so the water does not come in. This is also good for buoyancy as the boat can float and it would be hard for it to drown because there are a lot of buoyant points in the layers.

Then get your last 1 by 1m cardboard and cut it in half. Then tape the 2 pieces to the sides of the boat to add a bit more buoyancy make sure t put the pieces in the middle of the boat. Then get your 2 brooms and then tie your plastic bag and seel it on the broom and get on your boat together so the boat does not flip over and go to safety.