BOCCIA for Children

Boccia can be played by individuals, pairs, or teams of three. All events are mixed gender. The aim of the game is to throw leather balls — coloured red or blue (which side uses which is determined by a coin toss) as close as they can to a white target ball, or jack. The jack is thrown first, then the first two regular balls are played (first, the player who threw the jack then the opposing side), after which the side furthest away from the jack goes next in an attempt to either get closer to the jack or knock the opposition's ball out of the way. In this fashion, each end will continue until one side has played all their balls, at which point, the opposing side will play their remaining balls. The balls can be moved with hands, feet, or, if the competitor's disability is severe, with an assistive device such as a ramp. At the end of each round, or end, the referee measures the distance of the balls closest to the jack, and awards points accordingly — one point for each ball that is closer to the jack than the opponent's closest ball. The team/player with the highest number of points at the end of play is the winner. If both teams have the same number of points after all ends have been played, one additional end is played to determine a winner.

1. Birz plate- 430/485/18 MM- for CNC

green PLA roll - for 3D printing

1. PVC wheel Top plate- 3 PC

2. Metal pipe- 200 MM ,External Diameter- 27MM, Internal Diameter-19MM.

3. Metal pipe- 200 MM ,External Diameter- 19MM.

4. PVC pipe- 1000 MM, Internal Diameter- 4".

5. Wood screws- 3.5/18 -12 PC.

6. Wood screws- 3.5/30 -5 PC.

7. Hex Head Screws- 6MM, 35MM- 3PC.

8. Hex Head Nuts- 6MM- 3PC.

9. Electirc Lock Cabinet - 12V- 2 PC.

10. 5.5/2.1 DC Female Barrel Connector.

11. Philmore 3.5mm Female.

12. Pan Head Phillips Screws- 5M, 15MM- 3PC.

13. Nuts- 5M- 3PC.

14. Wooden dowel- 8MM, 35MM.

PVC pipe- 1000 MM, Internal Diameter- 4".

1. Cut to a little over a third.
2. cut the Edges.
3. heat after 10 CM and band.

Metal pipe- 200 MM ,External Diameter- 27MM, Internal Diameter-19MM.

1. Drill on page 10 mm below the edge, Diameter 7 mm
2. Weld the nut to the hole (be careful not to damage the thread)

1. Cut the tube in half up to 8 cm below the edge (image)
2. Weld the 2 nuts:

1. 10 MM below the edge

2. 45MM below the edge

1. Sand the inner radius of the CNC parts
2. Connect the parts

Attach the three screws to the base

Attach the wider pipe using the printed connector and screws to the base.

Screw the adjusting screw into the nut

Thread the narrow pipe into the wide pipe.

Attach the slide guide to the pipe with the screws (do not tighten the screws)

Connect the slide to the slide guide,

Screw the screws through the two parts of the connector (image).

If you can lay the ball by yourself on the slide then there is no need to continue, the slide is ready!

conect the head connector to the slide 10 cm after the edge.

Note that the holes are in the right direction!

Insert the electronics into the shell as shown in the image

Close with the lid and lock with the screws and nuts.

After locking, insert the wooden dowels into the lower holes

Connect the head

Done!