Ardunio Smoke and Gas Sensor(MQ-2)

Hello everyone , I have got another super easy arduino tutorial, this time is on the MQ-2 gas and smoke detector. Mostly combustible gases, propane and hydrogen.Its very easy to connect and program. Just using the map function.

So the code is simple to understand, the G lights when gas level is greater than 20 and less than or equal to 30, i started from 20 because i noticed that when you map it in an open space the initial values without the presence of combustible gas or smoke is often between 14-19, so safe so zone.

And the B lights up when gas level is greater than 30 and less than 60, the not so good zone. while the R lights up when gas level is greater than 60 and less then or equal to 90, so danger zone. This is my code and you can choose your range of values as you wish.

//GAS sensor output pin to Arduino analog A0 pin
#define R 2
#define G 7
#define B 5

#define MQ2 A0

int gaslevel;

void setup()
{
Serial.begin(9600); //Initialize serial port - 9600 bps

pinMode(MQ2,INPUT);
pinMode(R,OUTPUT);
pinMode(G,OUTPUT);
pinMode(B,OUTPUT);
}

void loop()
{
  gaslevel=(analogRead(MQ2));
  gaslevel=map(gaslevel,0,1023,0,255);
	
 if(gaslevel > 20 && gaslevel <= 30){//gaslevel is greater than 20 and less than 30
    digitalWrite(R,LOW);//green led is off
    digitalWrite(B,LOW);//blue led is off
     _delay_ms(500);//delay
    digitalWrite(G,HIGH);//red led is on
  _delay_ms(500);
  }
  else if(gaslevel > 30 && gaslevel <= 60){//gaslevel is greater than 30 and less than 60
        digitalWrite(R,LOW);//red led is off
         digitalWrite(G,LOW);//green led is off
         _delay_ms(500);
    digitalWrite(B,HIGH);//blue led is on
    
      }
      
       else if(gaslevel > 60 && gaslevel <= 90 ){//gaslevel is greater than 60 and less than 90
        digitalWrite(G,LOW);//red led is off
        digitalWrite(B,LOW);//blue led is off
         _delay_ms(500);
    digitalWrite(R,HIGH);//green led is on
      }
      else
      {
         digitalWrite(G,LOW);//red led is off
        digitalWrite(B,LOW);//blue led is off
    digitalWrite(R,LOW);//green led is off
      }
  Serial.println(gaslevel);//print values on serial monitor
  _delay_ms(100);
}

you can also change your indicator, maybe a piezo buzzer or motor instead an LED. I made a minute video you can watch it and see how it works.Thank you and have a good day. :)