ARM DECORATION WITH BASE

Good night, afternoon, day have everyone

Today I will present a base with a metallic arm or well in this case it will be for the custom that can be used as a pedestal or simply as a beautiful decoration for your home.

Well to start we do not need absolutely anything good apart from the Fusion 360 to design it and a little knowledge in it then just patience and you can make it incredible.

This is the bottom of all and the most detailed so pay attention to the maximum:

-We create our sketch by selecting any side but preferable from the sides for less confusion.

-We proceed to with the line tool proceed to follow the plane placed in the image which can be easily seen and we finish the sketch.

-We use the revolution tool when we already have the plane and the entire shape made just by clicking it and selecting the left side as seen in the image.

-When we have it like this, we use the splicing tool to give a couple of arrangements to certain sides with the measurements seen in the images.

-At the end of the splice we select the upper part of our project and with right click we put on create sketch.

-After putting that, we put a circle right in the center of 20mm and we finished the sketch.

-Now we extrude the circle that we have just made but downwards as much as we really want and we will have the upper part.

-Now we are located in the lower part and we do the same thing only now a 110mm circle and we extrude it with -110mm.

-It would be finished that way, we just give it something personalized with an appearance and we keep it.

This one is actually super easy so we'll do it in a couple of steps:

-We create a new sketch now by selecting the bottom side.

-We follow with the circle tool the plane that is in the image.

-We finish the sketch and with the extrude tool we do it with 15mm.

-We keep it.

This is one of the most difficult parts but at the same time not so much so I proceed to explain it and do it

-First we create a new sketch where we will select the right side.

-With the line tool we make a small square like 20mm and then use the spline tool to make some lines to your liking that if we have to be careful with the curves that we make because it will result if no error in the next step and we finish sketch.

-We use the pipe tool in the create section and select our line that we made and then mark the gap box so that they are more or less 10mm but it is customizable in reality.

-After having all the sides saved, we open a new sketch and first put the base that ocn the union tool that is in assembling we will put the ring that we made on top.

-Then we move the pipe and join it to the hole in the center of the ring, this can be adjusted as desired.

-And that's how everything would be, we just customize it as we want and that's it.



We will have a nice decoration for our house

I hope you liked it and do not hesitate to see my other projects that I hope you like

Leave a comment and others in any doubts

Thanks for watching.