A Book Holder, for When Your Cooking in the Kitchen or Studying for a Final.

I made a book/page holder, and here is how I did it.

For supplies, you'll need the correct measurements of the book and measurements of the holes you will install.

A book with proper measurements

Tinkercad

3D printer

1st measure the book you want this to fit.

2nd go onto Tinkercad and build the legs and the stand customizing to you.

3rd refer to the picture when building the legs you want to keep in mind that you will have to connect the legs to the stand, so your circle will have to fit in the stand. The stand will have to be the same measurements as the book you'd like it to fit. You'll want to have the legs be able to hold the pages as well.

put the chip into your computer and start printing.