3D Spinning Pendant

This is a 3D spinning pendant it is all done on TinkerCaD.It is a 3 piece 1 spinning part it is 85x85It took me about 2 weeks and a half to make this pendant. It is unique Because you could use it even as a pocket watch pop on any chain even if you want you could change the colors to your liking.

TinkerCAD, PLA Filament, Voxel 3D Printer, Necklace chain

The first step is to add-a-ball put the height to 1.

The second step is to make the width and length 80mm.

The third step is to copy and paste another Circle End to one of the circles you would like to cut in half.

The fourth step is to add a cylinder to the middle of the half-circle make the cylinder 6x6mm and the height 8mm then You have to make the Locking MechanicFirst, you will have to make a hole 3x3mm on the cylinder underneath or in the middle

if you want you could customize but make sure not to go any over the edges so I will show mine and it's not going over the edges.

The fifth step You would like to make the other Circle you saved You would like to raise it 21 mm Then cut a circle in the middle not all the way down though because it will be Hollow they make it 95x95mm make the whole inside 86x86mm Cut a hole in the center middle and I will show it and the image.

The six-step You go back to the first step And just make a circle again 80x80mm Make a hole in it Make sure it's in the center Make the hole 7x7 mm If you want you also could customize I will show you one of my customers

The seventh step is to put it all together First you would like to Get the half-circle circle with the two cuts and put them together with something you can work on to make sure there is a gap in the middle.

Put it all together and printed.