3D Printed Folding Space Drone

I just want to build a new kind of quad copter, and it's end up just like space ship... and because it's a drone, so it's a space drone... :)

This video will concentrate at the frame assembling only, even though i put some component in the sequence, all the component it's really depend on the Flight Board or Flight Controller u will use...

See assemble video above...

Some part that u need is (for Frame only):

• Voltus/Fatboy 3D parted part,u can download it from https://www.thingiverse.com/thing:2844836
• 16mm OD x 16cm Carbon Tube (lenght of the tube can be up to you)
• 4 x M3 40mm Bolt (for arm axle)
• 5 x M3 25mm Bolt & Nut (for leg and tail battery)
• 16 x M3 25mm Bolt & Nut (for motor holder)
• 22 x 2mm diameter, 10mm long screw (for top plate, bottom plate, CF hinge lock, top cover)
• some hot glue & some extra screw, nut and bolt will be better

And for the electronic part is not must but at least have this:

• Flight Board or u can use APM other newer FC like NAZA for better quality
• if u use to APM FC u need power module and additional part like Minim Micro OSD, 3DR Telemetry Module, M8N GPS, LED & Buzzer driver, Motor LED
• If u want to FPV or Arial Camera u need 3D gimbal, 600wm at least VTX, 4K action cam or else
• Power Distribution Board (include UBEX 5v and 12v is recomended), 30A OPTO ESC, 2212 brushless motor, 1145 prop, 4S Lipo Battery (4200mAh is better)
• Silicone AWG for better cabling
• Remote Control and Receiver

I try to make it fordable and can fit in my tools box...